Threading Your Punch Needle
Learn step by step how to thread a punch needle, from pulling the threader through the needle to threading the eye.

Punch needle embroidery is a popular technique where you use a special needle to punch into the fabric. Flat stitches appear on one side and loops appear on the other. By combining different techniques and yarns, you can make all kinds of projects.
Supplies
- Threader
- Punch needle
- Yarn that is thinner than the diameter of the needle
Threading the punch needle
Most needles come with a wire threader. Always thread the largest part of the needle first.

Push the threader from the front of the needle toward the base. This means you do not have to cut the thread or wool, and you can work while the thread is still attached to the skein or ball.

Pass the thread through the threader and pull it back to draw the thread through the needle. Do not pull on the thread yet before both openings have been threaded, otherwise the thread can get stuck inside the needle.
Then thread the smaller hole, the eye, by pushing the threader in from the back of the eye. Pass the thread through the threader and pull the threader back. Your punch needle is now ready to use.
Threading an Oxford Punch Needle
Threading an Oxford Punch Needle works differently. This needle has a groove from the tip to the base. Thread the eye and then lay the yarn into the groove. After that, you can start punching.

If your thread keeps catching
Check whether the yarn runs smoothly through the needle and whether the ball or skein can unwind freely. Do not pull on the thread while punching. The thread needs to feed through in a relaxed way, otherwise you will pull the loops on the back loose again.
Want to follow the technique from the beginning? Also read punch needle for beginners.
